Traditionally, the cigars were made from the simplest technology in that only some special papers were used to wrap the dry tobacco which was then lit to burn so as to produce the smoke that contains some traces of nicotine. It is this nicotine that the smokers are after. Actually, this is the motivation behind the smoking. After technological advancements that have been witnessed in almost every sector of life, it has also found a way of impacting on the smoking industry in that today you can now have an electronic cigar. This is a special gadget that is made in such way that it resembles the traditional cigar. It is not supposed to be lit just like the traditional cigars; it is powered by the battery that is fitted in the device which is always recharged. The role of the battery is to make sure that it has supplied the power that will be able to trigger the heater to start heating the liquid tobacco that is in the reservoir so as to produce the steam. Once the steam gets out the device, it is then inhaled by the smoker. This article will therefore look into the various components that make up the e-cig to work. Here are some of these components;

• Heating element
• Mouthpiece
• Reservoir

Heating element

This is a heater that has a responsibility of heating the liquid that is extracted from the raw tobacco. It relies on the power that is supplied with the battery. The battery should therefore be charged with the electricity. Before the device is about to be used, the battery charge ought to be checked out. If the level of the charge is too low, then you need to make sure that you charge the battery as this is what the whole device is depended on. Through this, you can rest assured that you an e-cig will be able to serve you for a longer period of time.

Mouthpiece

This is the part of the cigar where you need to put the device on your mouth from. It is through this part that you really need to inhale the vapor from. Besides this function, the mouthpiece also has a sensor that is able to detect your intention to inhale the vapor from the device. It then triggers the heater so as it can heat up the liquid tobacco so as it can produce the vapor that you need to inhale. This is one of the components that completely make the device electronic.

Reservoir

This is a special tank that is meant to hold the liquid tobacco before it is being heat. It needs to be checked from time to time to ensure that the reservoir contains enough liquid that will be heated for the steam to be produced for it to be inhaled. As a routine maintenance practice, you need to make it compulsory to check the level of the liquid because this is the only way to keep an e-cigsafe.

Clare Louise